Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGhost Controls Keypad & Intercom Repair: The Flower Mound Owner’s Guide
Ghost Controls keypad and intercom repair in Flower Mound typically runs $145 to $310 installed, depending on which component failed and whether we replace the keypad, the intercom module, or both. Our trucks carry the most common Ghost Controls keypad and intercom parts, so our technicians can usually complete the swap in a single visit and test the full system before we leave. Most Flower Mound owners discover the failure the hard way: the keypad lights up but won’t open the gate, the intercom rings the house but the voice is scratchy or dead, or the keypad takes ten hard presses before the gate finally responds. It starts as an annoyance, then worsens, then quits on a morning when you’re already late.
Which Ghost Controls Models This Applies To
We work on Ghost Controls wired and wireless keypads across the current lineup, including the AXDP and the wireless keypad kits that pair with the AX 760, AX 4100, and TSS1 opener series. If your system was installed in the last ten years, chances are we see it every week. The keypad and intercom pair with the main control board by a simple two-wire connection or radio signal, and the part number is usually on a label inside the battery compartment or behind the mounting plate. Take a picture of that label before you call us; it saves a trip and helps our Flower Mound techs bring the right part the first time.
One compatibility gotcha we run into often: Ghost Controls changed their keypad wiring colors between older and newer production runs, and color alone is not a reliable guide. If a homeowner wires a newer keypad using old instructions, the keypad can power up but never communicate with the board. We match by part number, not wire color. We also stock quality aftermarket equivalents for common Ghost Controls keypads, and our honest recommendation is simple: OEM is preferred when available, but a properly rated aftermarket unit from a supplier we trust can serve just fine if the OEM part is backordered. We’ll tell you which one makes sense for your system and your budget, and we’ll quote both before any work begins.
Signs Your Ghost Controls Keypad & Intercom Repair Is Failing
- Keypad backlight works but the gate won’t move. The keypad is getting power, but the signal isn’t reaching the opener board. Usually a wiring fault or a corroded connection inside the keypad housing. Intermittent response is the warning sign that full failure is coming.
- You have to press keys hard, or press them twice. Ghost Controls keypads use a rubber membrane over contacts. Texas heat and rain degrade that membrane over time, and once it starts, it does not heal. The repair is a new keypad, which is a quick job.
- Intercom rings the house but the audio is garbled, humming, or silent. Moisture inside the intercom station is the usual culprit in Flower Mound’s humid springs and stormy summers. Once corrosion reaches the audio board, replacement is almost always the honest fix rather than repair.
- Keypad works from six feet away but not from the driveway. If this is a wireless keypad, the antenna or the radio module is failing, or the battery contacts have corroded. Range shrinking over time is a classic Ghost Controls wireless symptom before total dropout.
- The gate opens by remote but not by keypad. This isolates the problem to the keypad or its wiring, not the opener itself. Good news: it’s the cheaper half of the system to replace, and the fix is straightforward.
Replacement Cost & What’s Included
In Flower Mound, a Ghost Controls keypad replacement installed usually falls between $145 and $220, and an intercom station runs $190 to $310 installed. If both the keypad and intercom failed together, which happens after a bad storm or a power surge, the combined job typically lands around $330 to $430. The range comes down to three things: which Ghost Controls model you have, whether we use OEM or a quality aftermarket part, and how much rewiring the existing setup needs. Our quoted price includes the part, the labor, the wiring check, and full testing with your opener and any secondary entry points. We settle the price before a single screw is turned. Every completed job is protected by our written 90-Day Done Right Promise: if it is not right, we come back and make it right, no paperwork and no arguing. That’s the Keystone Standard, and it applies to every Ghost Controls repair we do in Flower Mound.
DIY or Call Us?
There’s a safe middle path. You can check the keypad’s battery or power supply, confirm the breaker feeding the system hasn’t tripped, and press every key to see if the problem is one failed button or the whole unit. Those checks are free and we’ll walk you through them over the phone if you call (254) 345-4831. What we don’t recommend is opening the keypad housing or the intercom station if you’re not familiar with low-voltage wiring. It’s not a dangerous voltage in most cases, but the boards are tightly packed, the ribbon cables are fragile, and a homeowner with a screwdriver can turn a $200 keypad swap into a damaged control board. If the failure is outside the easy checks, call us. We’ll quote it up front, bring the right part, and finish most Ghost Controls keypad and intercom repairs in a single visit.
FAQs
A Ghost Controls keypad in Flower Mound’s climate typically lasts 4 to 7 years before the membrane, contacts, or internal seals degrade. Sun exposure on a west-facing column shortens that, and keypads under a shade cover tend to outlast fully exposed ones. If your keypad is older than five years and acting up, replacement usually makes more sense than chasing the problem.
Most Ghost Controls keypads are not economically repairable once the membrane or board has failed, because the replacement internals cost nearly as much as a new keypad and won’t carry our warranty. We will always tell you if a simple cleaning or terminal tightening will fix it, but when the part is done, we tell you straight. Call (254) 345-4831 and we’ll be honest about whether repair is worth it.
A Ghost Controls keypad or intercom replacement in Flower Mound typically takes 45 to 90 minutes, including wiring verification and full system testing with your opener and any secondary entry points. We bring the part on the truck whenever possible, so most jobs are done in one visit.
Yes, we stock the most common Ghost Controls keypad and intercom parts on our service trucks, and we can source the rest quickly through our supply chain. We also stock parts for LiftMaster, Mighty Mule, and DoorKing, so if your system is mixed-brand, we can still handle the whole job in one call.
Call Ironworks Gate Co. for Ghost Controls Keypad & Intercom Repair in Flower Mound
If your Ghost Controls keypad or intercom is acting up, call (254) 345-4831. A live person answers, 24 hours a day, 7 days a week. We’ll ask a few questions about what the keypad is doing, give you an honest sense of what the repair will cost, and schedule a visit on your time. Free estimates, upfront pricing, and the 90-Day Done Right Promise on every job. Victor Salinas grew up in the Lakeside area of Flower Mound when this town was mostly open land, and the company he runs has been serving neighbors here for over 42 years. Metal remembers how it was treated. So do customers. We aim to be the last call you ever have to make about that gate.
Written by Victor Salinas, Owner, Ironworks Gate Co. at Ironworks Gate Co., serving Flower Mound and nearby areas.